1. Add DHCP function to IP addressing
2. Add Open Socket at LAN port 5025
3. Add over current protect function in a special case
4. Fix a crash fault when restoring settings
5. Modify the calibration arithmetic in 2-wire resistance
measurement 10 MOhm range
6. Add “ABORT BULK IN” ,”INITIATE CLEAR” features
to remote SCPI commands

1. Add and optimize the manual calibration function
2. Solve the socket communication in multiple cycles of open/close, may not respond to the problem
3. Fix the problem that the “READ” command does not match the description in the programming manual
4. Fix the key test screen no prompt
5. Optimize the connectivity test buzzer response speed issues

1. Add the scan card setup save&recall function.
2. Optimize the slot time of the channel switching of scan card.
3. Optimize flash R&W design.
4. Fix some UI & SCPI bugs.

1. Fixed some crash fault about U disk save &recall.
2. Fixed some bugs about “acquire” function.
3. Improve the trend display function.
4. Fixed some bugs about communication with easysdm

1. Add U disk recovery function
2. Add the update of the calibration data function
3. Fix the bug of a few abnormal DCV measurements when the input terminal is shorted
4. Repair the external trigger problem
5. Add the telnet SCPI function; port is 5024
Example: telnet 192.168.0.10 5024
6. FPGA optimization